Husqvarna BMC 335 Manual Del Usuario página 25

10. Install the HTD drive belt (G) and the HTD pulley (H).
G
®
11. Apply LOCTITE 243 to the thread of the motor axle.
12. Install the bushing (D) with the screw (C).
13. Install the scarifying drum.
14. Install the side cover.
1816 - 002 - 22.03.2023
15. Install the support plate.
H
16. Measure the drive belt tension in the center of the
D
C
17. If it is necessary, adjust the drive belt tension with
18. Tighten the nut (C).
drive belt span (A). Correct tension is 117 Hz.
B
C
the nut (B).
A
25