Gardenline 21994-18 Manual Del Usuario página 5

*Before inserting any screws, please review Fig. 1 and Fig. 2 above to
see the correct orientation of the parts in this step. Note that the rail
intended for the Netting Panels (M) should be facing inward and both
Frame Connectors (J) should be facing outward of an erected unit. Do
not tighten screws down completely during this portion of assembly.
Fig. 1
P
B
P
(12) M6X15 mm Screw
STEP 2:
Bring one Left Frame (B) and Right Frame (C) together so their open
ends meet. Insert one Screw M6x15mm (P) through Frame Connector
(J) and into the lower bar of Left Frame (B). Insert one Screw M6x15mm
(P) through Frame Connector (J) and into the lower bar of Right Frame
(C); see Fig. 1.
STEP 3:
Place Frame Connector (J) against the top bars of where these parts
meet. Insert one Screw M6x15mm (P) through Frame Connector (J) and
into Left Frame (B). Do not insert any screws through Frame Connector
(J) and into Right Frame (C). This will be completed in a later step in this
manual.
Repeat these steps to assemble the remaining Left Frames (B) and Right
Frames (C) together.
8
support@tdcusainc.com
MODEL: 22095-18 PRODUCT CODE: 7884
Assembly Instructions
4X
J
C
Fig. 2
J
P
AFTER SALES SUPPORT
04/2018
USA
*Please review Fig. 1 to see correct orientation of Left Frame (B) and
Right Frame (C) with Pole (A). Please note this figure is looking at
this corner from a prospective inside an erected unit. Part C is on
the left side of A and part B is on the right when on the inside of the
gazebo frame. Do not tighten screws down completely during this
portion of assembly.
C
STEP 4:
Place Left Frame (B) of an assembled frame against Pole (A). Please
note that the Ring Screw (R) should be below where Left Frame (B) is
being connected to Pole (A). Insert two Screws M6x15mm (P) through
Left Frame (B) and into Pole (A). On the adjacent side of the same Pole
(A), insert two Screws M6x15mm (P) through Right Frame (C) of a second
assembled frame; see Fig 1.
STEP 5:
Insert one Screw M6x15mm (P) through Support (G) and into the bottom
of Right Frame (C). Insert one Screw M6x15mm (P) through Support
(G) and into the bottom of Left Frame (B). Insert second M6x15mm (P)
through opposite ends of both Supports (G) and into Pole (A). See Fig.
2 for further reference.
Repeat these steps to connect assembled Left Frame (B) and Right
Frame (C), and Supports (G) with remaining Poles (A).
AFTER SALES SUPPORT
1800 599 8898 1800 599 8898
MODEL: 22095-18 PRODUCT CODE: 7884
P
C
B
G
B
B
C
04/2018
USA
Assembly Instructions
Fig. 1
Fig. 2
C
P
B
P
(32) M6X15 mm Screw
9
support@tdcusainc.com