Panasonic AJ-YA93P Manual De Instrucciones página 4

6.
Mount the terminal board using the four screws.
Terminal board
7.
Set the optional board.
SW100
Switch no.
AUDIO INPUT IMPEDANCE SW
SW1
For setting the audio input impedance of
channels 1 and 2
HIGH/600 Ω
AUDIO INPUT IMPEDANCE SW
SW100
For setting the audio input impedance of
channels 3 and 4
HIGH/600 Ω
The underlined item denotes the factory setting.
E-5
SW1
Purpose of setting
8.
Insert the optional board into slot [4] in the AJ-SD93
with the connector located to the side of the rear panel.
connector
Take care not to pinch
the DV connector cable.
If this cable is sticking
out, put it back
between two boards.
Take steps to ensure
that the cable is not
caught or sandwiched
when screwing the
top panel back on.
9.
Attach the board clamp using the two screws.
Slot [4]
DV connector cable
Board clamp
E-6