Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging and
wiring. (Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7´ of clearance
from floor to blades. (Figure 2)
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and
capable of withstanding a load of at least 35 lbs.
Failure to verify that the screws are properly installed
could result in the fan falling.
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may
result in damage to the fan blades.
1.
Securely attach the outlet box acceptable for ceiling
fan support into the building structure. Outlet box is
not supplied with the fan. (Figure 3)
2.
Remove the three screws from the ceiling bracket
assembly and retain for later. (Figure 4)
3.
Using the outlet box screws and washers provided
with the outlet box, securely attach the ceiling bracket
to the outlet box as shown. (Figure 5)
How to Hang and Wire Your Ceiling Fan
Ceiling
Floor
NOTE: Supply wires and
fan wires omitted for clarity
NOTE: Supply wires and
fan wires omitted for clarity
Flat Washers (2)
Screws (2)
7
Main Fuse Box
Figure 1
No Less
Than
7 Feet
Figure 2
Outlet Box
Figure 3
Ceiling Bracket
Assembly
Figure 4
Outlet Box
Ceiling Bracket
Assembly
Figure 5
Publicidad
