Schulz CPS-40 Manual De Instrucciones página 34

5. MAIN COMPONENTS
FIGURE 1
1. Machine on indicator LED;
2. LED overheat indicator;
3. Current adjustment potentiometer;
4. Negative output terminal: torch connection;
5. Torch drive connector;
6. Positive output terminal, work cable connection;
7. Pressure regulator;
8. Connection for compressed air inlet hose;
9. Manometer;
10. On/off button;
11. Power cord;
12. Purger;
6. APPLICATION
6.1 Plasma cutting
Work Clamp (Ground) Connection – To cut, mount the Work Clamp (Ground) connector on the positive (+) pole;
Torch Connection – The torch must be connected to the negative (-) pole.
Torch trigger connection – the trigger connector must be connected to output (5) between the poles;
FIGURE 2
34