SNOWJOE sunjoe 24V-ST14B-CT Manual Del Operador página 12

m
WARNING!
Do not operate the grass trimmer in a tree,
on a ladder, or on a scaffold; this is extremely dangerous.
Maintenance
m
WARNING!
Make sure to remove the battery before
inspecting its parts.
m
WARNING!
Always wear protective gloves during
maintenance tasks. Do not carry out maintenance when the
motor is running or hot.
• Your trimmer line can dry out over time. To keep your line in
top condition, store spare pre-wound spools or bulk line in
a plastic resealable bag with a tablespoon of water.
• Never use water or chemical cleaners to clean your grass
trimmer. Wipe it clean with a dry cloth.
• Plastic parts may be cleaned by using mild soap and a
damp rag.
• Always store your grass trimmer in a dry place. Do not allow
any liquid to get inside it.
• Keep the motor ventilation slots clean.
IMPORTANT! To ensure product safety and reliability, repairs,
maintenance, and adjustments to this power tool should be
performed only with identical replacement parts. Contact your
authorized Snow Joe + Sun Joe
®
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
Replacing the Spool + Clearing Jams
and Tangled Lines
m
WARNING!
Remove the battery from the battery
compartment before changing the trimmer line.
m
WARNING!
Never use metal-reinforced line, wire,
or rope, etc. These can break off and become dangerous
projectiles.
NOTE: 16.4 ft. (5 m) dual-line replacement spool
(model 24V-ST14B-SPOOL) is available for use with the
24V-ST14B-CT grass trimmer. Visit snowjoe.com to purchase
this accessory online. Always use the recommended nylon
cutting line with diameter no more than 0.080 in. (2 mm). Using
line other than that specified may cause the grass trimmer to
overheat or become damaged.
1. Press together both release tabs on the line spool cover
and remove the cover and spool by pulling it straight off
(Figs. 16 & 17).
dealer or call the Snow Joe
®
Fig. 16
Fig. 17
®
2. Remove the spool out of the spool cover (Fig. 18) and
clean out the remaining cutting line, remove any jams, or
dirt and grass residue.
Fig. 18
3. Re-insert the spool into the spool hub as follow, or insert a
new pre-wounded spool (Fig. 18).
4. Insert each line end through its respective eyelet on each
side of the spool cover and gently press the spool down
(Fig. 19).
12
Spool cover
Spool releasing tab
(on both sides)
Spool cover
Spool cover
Spool
Spool hub