Mark MOVILED BEAM 712 Instrucciones De Usuario página 4

EN
requirements of the unit.
It's important to ground the yellow/green conductor toearth in order to avoid electric shock.
The unit is for indoor use only. Use only in a dry Iocation.
The unit must be installed in a iocation with adequate ventilation, at least 50cm from adiacent
surfaces. Be sure that no ventilation slots are blocked.
Disconnect main power before replacement or servicing.
Make sure there is no flammable materials close to the unit while operating as it is firehazard.
Use safety cable when fixes this unit. Don't handle the unig by taking its head only, but always
by taking its base.
Maximum ambient temperature is ta:4 0ºC
Unit surface temperature may reach up to 85
during its operation. Turn off the power and allow about 15 minutes for the unit
to cool down before replacing or serving.
In the event of serious operating problem, stop using the unig immediately. never
try to repair the unit by yourself. Repairs carred out by unskilled people can lead
to damage or malfunction .please contact the nearest authorized technical
assista nce center. always use the same type spare parts.
Do not touch any wire during operation as high voltage might becausing electric
shock.
3.Warning
To prevent or reduce the risk of electrical shock or fire ,do not expose the unit
to rain or moisture.
Do not open the unit within five minutes after switching off.
The housing, the lenses, or the ultraviolet filter must be replaced if they are
visibly damaged.
Caution:
There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that
the unit is firmly fixed to avoid vibration and slipping while operating. And make
sure that the structure to which you are attaching the unit is secure and is able
to support a weight of 10 times of the unit ' s weight. Also always use a safety
cable that can hold 12 times of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where
is out of the touch of people and has no one pass by or under it.
4.Operation Instructions
The moving head is an LED wash lignt for onsite decoration purpose.
Don ' t turn on the fixture if it' s been theough severe temperature difference
MOVILED BEAM 712
.Don't operateif the temperature is higher than this.
ºC
User Manual/Manual de uso
. Don't touch the housing bare - hand
Pag 2