Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Cat. No. ..................................................... 2356-20
Battery Type .................................................M12™
DC Input Volts....................................................12 V
Output Volts USB-A .............................................5 V
Output Amps USB-A ......................................... 2.1 A
Output Volts USB-C ............................................ 5 V
Output Amps USB-C............................................ 3 A
Operating Temperature
Battery and Tool ................................-4°F to 104°F
FUNCTIONAL DESCRIPTION
4
3
2
1
10
1. Light
2. Storage compartment
3. Battery cover
4. USB-C port
5. USB-A port
7
6
8
5
6. Fuel gauge
7. Power button
8. MODE button
9. USB power button
10. Handle
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To insert the battery, tilt the battery bay into the
"insert/remove" position. Insert the battery, ensuring
it latches securely into place. Tilt the bay back down
into the "use" position.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
To remove the battery, push in the release buttons
9
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To reduce the risk of injury, do not
CAUTION
stare at the operating light source.
To determine the amount of charge left in the battery,
turn the tool ON. The Fuel Gauge will light up for 2-3
seconds. When less than 10% of charge is left, 1 light
on the fuel gauge will flash 4 times.
To signal the end of charge, 1 light on the fuel gauge
will flash 8 times and the tool will not run. Charge
the battery pack.
If the battery becomes too hot, the fuel gauge lights
will flash and the tool will not run. Allow the battery
to cool down.
1. Insert the battery.
2. Press the power
3. Press the MODE button to cycle through High,
Medium, and Low.
4. Press the power
NOTE: The light will default to the selected brightness
the next time it is turned on.
Rotating the Light
To reduce risk of overheating, en-
CAUTION
sure the light is turned off before
storing or placing in the resting position.
To rotate the light, pull the light upward and rotate
up to 20° counter clockwise or 280° clockwise. The
resting position is LED light facing down into housing.
3
ASSEMBLY
OPERATION
Fuel Gauge
Using the Light
button to turn ON the light.
button to turn OFF the light.
Publicidad
