VOSTERIO B-619 Manual De Instrucciones página 6

INITIAL SETUP
ESSENTIAL SETUP
1. Place the unit on a flat and level surface.
The selected location should be stable and free
from vibration.
2. Insert the hinges into the slots on the transparent lid.
Then insert them into the hinge holders on the back
of the main unit.
3. Remove the tie-wrap that is holding the tonearm.
4. Place the slip mat on top of the turntable platter.
5. Connect the speakers to the speaker jacks at the
back of the unit.
6. Connect power adapter to the power jack of the unit.
Note: Do not plug the power adapter to power outlet before all the assembly is completed.
Before turning the power on, make sure again all the connection settings are correct.
Always turn off the power when connecting or disconnecting.
TURNTABLE PLATTER AND BELT SETUP
1.Insert the latter into the turntable spindle located in the middle of
the turntable, then rotate the platter until you see the drive motor
pulley through the window at the top right corner.
2.Carefully grab the drive belt and put it around the slot of motor
pulley.
TONEARM COUNTERWEIGHT ADJUSTMENT FOR STYLUS PRESSURE
The counterweight is a semi-automatic one, means you don't need to
adjust the dial.
The counterweight is pre-mounted on the tonearm, and the
tracking force of the dial has already been set in advance and it's within standard range (1-3
grams) no matter the counterweight is rotated on which part of the below tonearm.
While for better performance, we recommend you rotate the counterweight to the middle of
this part on the tonearm.
If you seek for a higher precision and optimal record playback, you can buy a stylus force
tracking gauge to test and adjust the tracking force.
4