Publicidad
Idiomas disponibles
Idiomas disponibles
13. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep discharging by
the "Discharging Protection System". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill will
start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you
can find the torque-adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque (screw driving
force) and position 18 is the highest torque (screw driving
force). Position is for drill operation. Regulate the torque
adjusting ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems and having not used a battery pack
for a prolonged time will reduce the battery pack working
time. This can be corrected after several charge and
discharge operations by charging & working with your drill.
Heavy working conditions such as large screws into hard
wood will use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery pack
below 0
C and above 40
C as this will affect performance.
o
o
EN
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
For Battery tools
The ambient temperature range for the use and storage of
tool and battery is 0
C-45
o
o
The recommended ambient temperature range for the
charging system during charging is 0
C.
C-40
C.
o
o
21
Publicidad
