Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Don't install the unit too low, no
less than 2.3 meter from the ground.
2.5 Don't allow gaps between the unit
and the wall. When hanging it from
the ceiling, use the enclosed ceiling
brackets.
3. INSTALLATION
A. Installing on concrete wall:
3.1.1 Remove the mounting plate
Unclamp the fixed screws on the back
of main body to remove the mounting
plate.
3.1.3 When the cement has frozen, fit
the mounting plate (use the washer
and nut according to the following)
2.4 When the entrance is wider than the
unit, it is recommended to install two or
more units in parallel. In this case,
provide 20-40mm gaps between the
units.
2.6 Don't install the unit in a place
where it might be splashed by water,
exposed to excessive steam, explosive
gas or corrosive gas.
3.1.2 Fix the bolts in the proper position
(Decide the position with the mounting
plate and pour cement into the bolt
holes.)
3.1.4 Install the main body
Set the main body onto the upper end of
the mounting plate and clamp it as
shown.
2
V.2
Publicidad
