SNOWJOE sunjoe SPX-EPB1 Manual Del Operador página 5

2. Slide the safety switch forward before pulling the trigger to
begin spraying (Fig. 10).
Fig. 10
Safety switch
3. When
extended, the sky lance can become very heavy.
Keep a solid footing and use the shoulder strap to pivot
the nozzle onto the cleaning area
Fig. 11
4. When not in use, slide the safety switch backwards to
lock the trigger and disconnect the sky lance from your
pressure washer.
NOTE: Always engage the safety switch before moving or
adjusting the sky lance.
Trigger
(Fig. 11).
Maintenance + Storage
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualified technician.
m
WARNING!
Do not use detergents, acids, alkaline
solutions, bleaches or solvents such as acetone to clean your
tool. These substances may damage the plastic housing of the
tool.
• Check for worn or damaged parts. Replace worn parts as
necessary or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563) for
repairs before using the product again.
• Store the tool and its accessories in a dry, frost-free, and
well-ventilated place out of the reach of children.
Service + Support
If your Sun Joe SPX-EPB1 18-ft Telescoping Pressure
®
Washer Sky Lance requires service or maintenance, please call
1-866-SNOWJOE (1-866-766-9563) for assistance.
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide
the model and serial numbers, which can be found on the
registration card. Copy these numbers into the space provided
below.
Record the following numbers from the housing or
registration card of your new product:
Model #:
S P X - E P B 1
Serial #:
5
+ Sun Joe customer
® ®