Philips AUT3234 Manual Del Usuario página 5

IV. Installation
Note:
- Before installation, it is important to check the condition of the system to
make sure it has not been damaged during transport.
- Unpack the system and its accessories. Remove the protective packaging material.
Recyclable materials have been used for the packaging and should be disposed
of in the appropriate recycling bins or at the specific local recycling center.
Warning: Keep plastic bags out of the reach of children, as they may be dangerous.
- Check if anything is missing according to the packing list and the overview.
- Given that the system will improve the quality of your drinking water, all tools
to be used in the installation process should be clean, rust and grease-free.
- The installation process should be carried out under appropriate hygienic
conditions, taking all necessary precautions concerning materials and components
that will come into contact with water to be treated or consumed.
- Avoid external contamination of the system through improper handling, using
gloves, sanitizing gel, and washing hands as often as is necessary during the
installation process, first use, and system maintenance.
- The system and installation shall comply with applicable local regulations.
- This product cannot be disposed of with other domestic waste products.
At the end of the product's service life, it should be returned to the place of
purchase, or at a local recycling center, indicating that it contains electric
and electronic components. The appropriate collection and treatment
of the product, which no longer are to be used, contributes to the
preservation of natural resources and avoids any potential public health risks.
1. Install the three-way ball valve
a. Turn off the cold water supply. Turn on the kitchen cold water faucet to release
the pressure and allow water to drain from the line. Disconnect the cold water
hose from the cold water valve.
Hot Cold
Cold
(1)
(2)
3