Publicidad
Idiomas disponibles
Idiomas disponibles
15. INSTALLATION
Remember that the hob must not be sealed to the kitchen countertop or any
other surface with silicone. If this is done, the warranty will no longer be valid.
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-
resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate. As shown below:
L(mm)
590
Under any circumstances, make sure the Induction cooker hob is well ventilated and
the air inlet and outlet are not blocked. Ensure the Induction cooker hob is in good
work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the
hotplate should be at least 760mm.
The safety distance between the induction hob and any object below it must
be at least 50 mm
A(mm)
760
W(mm)
H(mm)
D(mm)
520
55
51
B(mm)
C(mm)
50 mini
20 mini
A(mm)
B(mm)
X(mm)
560
490
50 mini
D
Air intake
E
Air exit 5mm
55
Publicidad
