Wiesenfield WIE-CCD-400 Manual De Instrucciones página 37

f - Plug to cover the light sensor
g - Guides
h - Voltage adapter (WIE-CCD-400 only)
Note: a screwdriver (not included) is a tool for assemblying the unit.
Place of installation:
• The controller should be mounted on the outer wall of the poultry house (the
controller has a light sensor).
• The controller should be installed above the hen entrance.
• It is recommended that the entrance measures max. 22 x 32 cm (width x
height).
The ambient temperature should not fall below -18°C.
•
In the case of power supply via a voltage adapter (WIE-CCD-400 only), make
•
sure that the connection to the power outlet is waterproof or adequately
shielded from the weather. It must be possible to disconnect the power
supply at any time.
Assembly
1) Install the left guide on the house with the self-tapping screws.