Publicidad
Idiomas disponibles
Idiomas disponibles
EN
26
INSTALLATION
Determine installation location
1.
Place the appliance with water dispenser upright.
2.
Place the appliance with water dispenser on a stable and level surface in a
cool, shady place near an earthed socket.
3.
Be sure that the back and the left side of the icemaker with water dispenser
are not closer than 10 cm and the right side not less than 15 cm from a wall or
obstacle and that the air can circulate freely between the wall or obstacle and
the icemaker with water dispenser.
Note: Do not connect the mains cable until the entire installation has been
completed.
Installing the drip tray with grid
Remove the drip tray from the packaging and slide it into the lower slot at the
front of the appliance until it is properly seated.
Install a water bottle (#1)
1.
Remove the plastic seal from the top of the bottle, but do not remove the
protective cap from the water bottle.
2.
Clean the bottle top and the bottle neck with a damp, warm cloth.
3.
Lift the bottle, turn it upside down and place it securely on the bottle holder.
The inside of the collar is equipped with a probe that pierces the lid of the
water bottle to prevent liquids and bacteria from entering the water.
4.
Wait 5 minutes for the water tanks to fill with water before operating the
appliance.
5.
Remove the air from the tanks by placing a cup under each water outlet and
drain at least 4 cups (1 litre) of water before first use.
Please note:
•
To avoid dry heating, do not switch on the heating and cooling until you have
completed the steps in this procedure.
Publicidad
