Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
BLADE REmOVAL (see figure 3-4)
• Lift up the cover release button.
• Slide the cover towards the on/off switch.
• Lift away from the housing.
• Lift the blade out.
RELEASE BUTTON
2
COVER
BLADE FITTING (see figure 5)
• Locate the end of blade under the retaining rib in the rear corner of the housing, press down
the whole blade until aligning the holes in the blade onto the pins.
• When refitting the cover ensure all location legs are inside the housing prior to sliding cover
into place.
• Slide the cover back towards the blade to secure.
1
ON/OFF
SWITCH
Fig. 3
14
BLADE
Fig. 4
Fig. 5
Publicidad
