Using The Remote Control; General Presentation; Setting The Date And Time - WPool E35 Guía De Instalación Y Uso

5. Using the remote control

5.1 General presentation

Your heat pump is equipped with a 3-button control programmed by default in hot mode at the factory. To
switch on your heat pump, press the ignition button for 0.5 seconds, to switch it off, press it again for 0.5
seconds.
OFF :
When the unit is in stand by you will see OFF
on the screen. After a while the screen will
turn off and the unit will be put in standby.

5.2 Setting the date and time

On the main interface, long press up or down to enter the password 022, then wait 2 seconds, select group
settings -> "v" and long press up and down to enter the clock settings
LED display
Down Up
ON :
When the heat pump is in operation, the
display shows the current water temperature.