SPC CONFORTO DC LITE 2 Manual De Usuario página 26

It is recommended to read the following instructions to ensure your safety:
1. The electrical installation must be carried out by someone qualified in ac-
cordance with the regulations in force in the country of installation.
2. Any action on the device's electrical connection, as well as its cleaning,
must only be carried out after ensuring that the power supply is disconnect-
ed, by removing the corresponding protective switch of the installation to
guarantee total isolation from the electrical supply.
3. You must ensure that the mounting bracket is fixed to a ceiling structure that
is capable of supporting no less than 30 kg through the supplied screws.
You need to make sure that the screws are screwed in along their full length.
If mounting over a ceiling junction box, you must secure the fan bracket
sufficiently to prevent it from loosening or twisting.
4. The earth cable of the fan must be connected to the earth network of the
installation, to avoid any risk to people.
5. Do not connect the power supply of the fan motor to any regulation com-
ponent or lighting switch, as this will cause the fan to malfunction and/or
damage its motor. For the electrical connection, it is necessary to incorpo-
rate a isolator switch in accordance with the installation regulations, which
ensures multi-pole cut-off, directly connected to the power terminals and
must have a contact separation on all its poles, which provides total dis-
connection under conditions of overvoltage category III. Only use the fan
controller to start or stop the fan.
6. It is recommended not to simultaneously use this type of fan in the same
room as gas installations.
7. The fan must be stopped and have stopped rotating completely before re-
versing its direction of rotation. This will prevent damage to your motor and
the control unit if applicable.
8. Do not insert anything that could hit the fan blades while it is rotating, as
it could cause injury to people, damage the blades, and cause the unit to
become unbalanced causing vibrations and wobble.
9. After mounting the fan, make sure all fixings are secure and tight to avoid
any noise caused by loose items.
26