SPC CONFORTO DC LITE 2 Manual De Usuario página 40

Note: Turn off the fan and wait for it to come to a complete stop before changing
the direction of the blades.
RECODING THE REMOTE CONTROL WITH
RECEIVER UNIT
1. Connect the power (wall switch) of the fan you want to control, and then,
within the next 10 seconds, press and hold the "LIGHT" key on the remote
control for 5 seconds.
2. A beep indicates that the connection has been completed and the equip-
ment can function normally.
3. The remote control and the receiver of the fan will have been synchro-
nised. Turn off the fan using the wall switch and turn it back on, this step
completes the syncing process.
Note: A single remote control can control several units of the same fan model. The
remote is specific to your fan model.
BALANCING - BALANCE PROBLEMS IN FAN
OPERATION
The swaying of the fan body during operation is not a symptom of malfunction
(even reaching a couple of centimetres). To reduce sway, you can, with the fan
switched off:
1. Check the distance of each blade from the ceiling. Measurement from
the ceiling can be done as the following picture shows.
2. Check that the fixing of all the blades is correct by tightening all screws.
40