SPC CONFORTO DC LITE 2 Manual De Usuario página 41

If after the previous steps the balance issue has not been resolved, it is neces-
sary to apply dynamic balancing, with the supplied kit, as explained below:
1. Run the fan on the highest speed to create the most rocking.
2. Turn off the fan. Select a blade and place the clip (see figure) on it, mid-
way between the bracket and the edge of the blade.
3. Turn on the fan, check if the rocking has worsened or improved. Turn it
off again, and if it hasn't improved, put the clip on another blade. Repeat
this process and determine which blade the swing improves on.
4. Leave the clip on the blade that produces the best result. Move the clip
back or forth on the blade until you find the position that works best.
5. Next, remove the clip and place one of the weights on top on the centre
line of the blade, at the height of the position where the clip was.
1
2
41
EN