Kreg Accu-Cut XL Manual Del Propietário página 7

ATTENTION
The guide strips are slightly shorter than an
individual track section, overlap the outer track-section joints, and fall
short of the ends of the complete track assembly.
With the track fully assembled and upside
down, apply the indexing labels (E) so they
read in sequence from left to right.
ATTENTION
The tracks can be taken apart for storage.
Reassemble them in number order, as indicated by the labels.
Slide the starting block (F) into the T-slots in
the end track (A).
Assembly
Guide-strip overlap
1
Outer track-section joint
2
3
A
4
F