Kreg Accu-Cut XL Manual Del Propietário página 8

Sled Assembly (Accu-Cut™ XL only)
Orient the Filler Strip
2
The filler strip (G) on the sled (H) is
shipped with the angled ribs facing
up. These ribs support a saw base with an
angled leading edge, keeping the saw base
flat on the sled when the set screws (I) in
the base-plate clamps (J) are tightened. For
a saw base with a flat leading edge, lift the
filler strip from the sled recess with the tip of
a screwdriver, turn it over to expose the flat
face, and press it into the recess.
Mount your Circular Saw on the Sled
3
Remove the indexing stop (K) from the
sled (H). Loosen the set screws (I) in
the base-plate clamps (J) and slide your saw
base plate under them. Position the saw on
the sled with the front of the saw base plate
against the step at the front of the sled. For
saws with the blade on the left-hand end of
the motor, center the blade in the left sled
slot. For saws with the blade on the right-
hand end of the motor, center the blade in
the right sled slot. To accommodate different
saw base-plate configurations, there are two
holes for attaching each base-plate clamp
to the sled. For the most secure clamping,
choose the holes that provide widest spacing
allowed by your saw. The clamps can be
oriented at an angle. Tighten the set screws
onto the saw base plate just enough to hold
the saw in place.
WARNING:
Disconnect the saw from power before mounting it on
the sled.
Assembly
K
H
G
I
H
G
I
J
J