Publicidad
SANITATION SYSTEM OPERATING INSTRUCTIONS
1. Activate the sanitation system:
Press the sanitizer button
activate the sanitation system as well as the fi lter pump. The
sanitizer icon and the fi lter icon turn green. Flashing code "003H"
appears on the control panel's LED, indicating that the unit is ready
to be programmed.
2. Set operating hours for the sanitation system:
With the minimum preset hours (code "003H") fl ashing, press the
sanitizer button
to increase the time from 003H, 005H to 008H
hours (see "LED CODE CHART" section). Pressing the
after the maximum number of hours (code "008H") will deactivate
the sanitation function and the LED panel will display the spa water
temperature. If you have selected too many hours keep pressing to
repeat the cycle. Once the operating time is set, the display LED
panel will stop fl ashing after 10 seconds and the sanitation system
starts working. For fi rst time use of the spa, set the operating hours
to "008H". During the sanitation, the information displayed on the
LED panel alternates between the spa water temperature and the
remaining hours of sanitation.
After the cycle is completed the LED panel displays the water
temperature. Test the water with the included test strips, and make sure the free chlorine
level is between 2-4 ppm.
Note: DO NOT press any other buttons on the control panel, ensure the heater is off and
attach the spa cover during the sanitizing process.
3. Readjust operating time if necessary:
During the sanitizing process, the operating hours can be re-adjusted if necessary. Press the
sanitizer button, the LED code "003H" will fl ash. Repeat step 2.
4. Turn off the sanitation system manually if necessary:
During the sanitizing process, you can turn off the sanitation system manually. Simply press
the ON/OFF button
sanitizer icon light will disappear.
5. Restart the sanitation system:
When the programmed cycle ends, the LED panel displays the water temperature, the unit
will stop sanitizing and the sanitizer icon light disappears. To restart the sanitation system,
following the above steps.
6. Test the SPA water regularly:
The free chlorine level in the SPA water may vary depending on the number of occupants,
local water condition and sunlight intensity exposure (outdoor use). During the initial use of
the spa, test the spa water at least 2 times per day with the included test strips to maintain
the free chlorine between 2-4 ppm. After the free chlorine level appears to be stabilized, test
the SPA water every week to maintain optimal sanitizing level.
S AVE THESE INSTRUCTIONS
(299IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 06/30/2016
on the control panel, this will
on the control panel. The sanitation system will stop and the
English
button
Page 14
299
A
Publicidad
