Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
WARNING! The charger and battery pack are
specially designed to work together so do not attempt
to use any other devices. Never insert or allow metallic
objects into your charger or battery pack connections
because of an electrical failure and hazard will occur.
1. CHARGING YOUR BATTERY PACK
1)
Do not use any charger other than that specifically
provided for use with the equipment.
2)
If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
3)
Please charge the battery to reach full before storage. If
the tool will not be used for long periods of time, charge
the battery every 3 months.
CHARGING PROCEDURE (SEE FIG. A1-A3)
1)
Plug the charger into an appropriate outlet. The light will
be green.
2)
Slide the battery pack into the charger, make sure the
battery is in the correct charge position firmly. the light
will turn to red to indicate the charging process has
started.
3)
When charging is completed, the light will turn to green.
4)
After fully charged, unplug the charger and remove the
battery pack.
NOTE: If the battery pack is locked in the charger, press
the battery pack release button and remove it
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for the
tool to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
Light
ON/OFF flash
Red on
EN
Green on
2. TO REMOVE THE BATTERY PACK (SEE FIG
B1)
Depress the Battery Pack Release Button firmly first and then
slide the Battery Pack out from your tool.
3. TO INSTALL THE BATTERY PACK (SEE FIG
B2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
OPERATION
1. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it to stop your
drill. The on/off switch is fitted with a brake function which
stops your chuck immediately when you quickly release the
switch.
It is also a variable speed switch that delivers higher speed
and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
•
Do not operate for long periods at low
speed because excess heat will be
produced internally.
•
When overload occurs, release the on/
off switch immediately to avoid the motor
overheating.
2. SWITCH LOCK
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
3. REVERSIBLE (SEE FIG. D1, D2)
For drilling and screw driving use forward rotation marked
"
rotation marked "
remove screws or release a jammed drill bit.
until it has stopped!
4. TWO-SPEED GEAR CONTROL (SEE FIG. F)
Status
The drill has a two-speed gear control designed for drilling
or driving at LO (mark is 1) or HI (mark is 2) speeds. A slide
Charging
switch is located on top of the drill to select either LO or
HI speed. When using the drill in the LO speed range, the
WARNING:
" (lever is moved to the left). Only use reverse
" (lever is moved to the right) to
WARNING:Never change the direction of
rotation when the chuck is rotating, wait
Fully Charged
19
Publicidad
