Publicidad
Idiomas disponibles
Idiomas disponibles
when using short screwdriver bits. When
screw-driving, apply a small quantity of
liquid soap or similar to the screw threads
to ease insertion.
12. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your
local waste authority for information regarding available
recycling and/or disposal options. Discharge your battery
pack by operating your drill, then remove the battery
pack from the drill housing and cover the battery pack
connections with heavy-duty adhesive tape to prevent
short circuit and energy discharge. Do not attempt to open
or remove any of the components.
13. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the
load on the machine immediately and allow cooling for
approx. 30 seconds at the highest no-load speed.
14. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 75 °C is exceeded, the
electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
15. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep discharging
by the "Discharging Protection System". When the battery
is empty, the machine is switched off by means of a
protective circuit: The inserted tool no longer rotates.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring,
EN
you can find the torque-adjusting ring between the chuck
and the drill body. Position 1 is the lowest torque (screw
driving force) and position 21 is the highest torque (screw
driving force). Position is for drill operation. Position
for hammer drill operation. Regulate the torque adjusting
ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery
pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy
faster than lighter working conditions. Do not re-charge
your battery pack below 0
affect performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
and above 45
as this will
C
C
o
o
is
21
Publicidad
