ALEAPOW O2 Manual De Instrucciones página 11

Operation
Inserting bits
1. Insert the bit in the magnetic bit holder.
2. Gently pull on the bit to check that it is properly fitted and does not come
loose
Removing bits
1. Pull hard on the bit so that it comes loose from the magnetic bit holder.
Changing the rotation direction
NOTICE!
Risk of damage to the unit!
Only use the rotation direction switch when the device is at a standstill
1. To screw screws into place, push the rotation direction switch (3) to the Left (rotation in
clockwise direction).
2. To remove screws, push the rotation direction switch (3) to the Right (rotation in an anti-clock-
wise direction).
- 09 -
If the rotation dire If the rotation dire
Check before sw Check before sw
Check to make s Check to make s
– Check to make – Check to make
– Check to make – Check to make
Switching on an Switching on an
– To start the too – To start the too
• The LED (4) wi • The LED (4) wi
– To switch the u – To switch the u
Screwdriver act Screwdriver act
– Keep the devic – Keep the devic
Note: Note:
Always use Always use
damage the damage the
Cleaning Cleaning
Cleaning overvi Cleaning overvi
Regularly and a Regularly and a
Preparing for di Preparing for di
Removing the b Removing the b
At the end of the At the end of the
– To remove the – To remove the
discharged. discharged.
– Remove the s – Remove the s
– Separate the c – Separate the c
– Dispose of the – Dispose of the
Disposal Disposal
Disposal of the Disposal of the
Applianc Applianc
househo househo
separate separate
– Please – Please
Through s Through s