Publicidad
Idiomas disponibles
Idiomas disponibles
1. Connect the power cable to an easily accessible, standard electrical socket.
Attention: Check that the voltage speci cations of the machine correspond to that of your power supply
network (220 - 240 V / 50 Hz).
2. Switch on the power switch on the rear side of the device.
3. Press the On/O button on the operating panel to switch the device on. The drive motor for the transport
rollers starts up.
4. Select the foil thickness: Press the button for selecting cold/hot laminating and foil thickness, several times
if necessary, until the LED beside the relevant foil thickness lights up in the operating panel. The LED strip
ashes red during the warm-up phase (approx.. 2 minutes (80 m setting), approx. 5 minutes (other settings)).
The LED strip lights up blue continually when the correct temperature is reached and the device is ready for
use.
Attention: If you have laminated larger foil thicknesses at higher temperatures beforehand, you must let the l
aminator cool down. The cool down phase can take up to 30 minutes.
The LED strip ashes red during the cool down phase.
5. Insert the document to be laminated in the foil pocket so that there is a margin of approx. 3 - 5 mm to the
edge of the foil on all sides.
Attention: Only use hot laminating foils!
Attention: Observe the permissible foil thicknesses (refer to Features)!
6. Insert the foil pocket containing the document in the laminator's infeed slot. Insert the ready closed side
of the foil in rst. The foil pocket, with the document inside, is automatically drawn in and sealed.
Note: To prevent the foil pocket from creasing, never feed the open side of the laminating pocket rst in the
infeed slot of the laminator.
Attention: The foil is very hot and soft when ejected following lamination. Therefore, handle the laminated
product with extreme care.
Note: To atten the laminated product, place a book or similar heavy, at object, on it.
Note: If the device remains unused for 30 minutes, it switches o automatically. Press the On/O button on
the operating panel to switch the device on again.
7. When you have nished your laminating tasks, press the On/O button on the operating panel to switch
the device o . Switch o the power switch on the rear side of the device. Also disconnect the power plug,
particularly when the device will remain out of operation for a longer pe-riod.
18
Publicidad
