Classic Flame 52EB497GRA Manual De Instrucciones página 4

1.) Open the master carton, stone box , side panel boxes and wall mounted control box
are on the top of product, take them out and put them in a safe location( see figure 1.)
2.) Cut the master carton along the cut line shown on the box, open the box.
3.) Take off the styrofoam ends from the builder box. Put the product over a big flat surface
with a raised flat blocks underneath the product to keep the product flat.
Recommended size of blocks are L 60 in x D 15 in x H 2 in ( see figure 2.)
4.) Unscrew 2 screws on the top edge of the frame. Securely holding the frame lift up and pull
away from the unit to remove the frame. Do not remove the protective plastic film at this time.
Place the frame in a safe place( see figure 3.)
Figure 1
Stones
Builder box
SECTION 1: PREPARATION
Side panel
FLAME
(2 pcs)
DOWNLIGHT
UPLIGHT
AUTO
Remote
Wall mounted
control box
2"
Figure 3
E-3
Figure 2
60"
15"