Classic Flame 52EB497GRA Manual De Instrucciones página 8

1.) Loosen the screw securing the junction box cover abd remove the cover.
2.) Pull the power supply wires through the hole in the cover.
3.) Pull out the 6 wires marked L, N, G, K1, K2, S from the junction box on the
builder box.
4.) Connect the black L wire from the unit to the black L from the power supply.
5.) Connect the white N wire from the unit to the white N from power supply.
6.) Connect the green ground wire from the unit to the ground from the power supply.
7.) Ensure that all connections are tight. ( see figure 10)
18AWG WIRE
( NOT SUPPLIED)
SIGNAL CABLE (SUPPLIED)
SECTION 4: WIRNG MAIN BOX
Black
White
Green
Green
G
18AWG WIRE FROM
POWER SUPPLY
(NOT SUPPLIED)
Black
Figure 10
Black
White
K1
K2
S
Black
SIGNAL CABLE
E-7