Nofer BIGFLOW EVO 01481.S Manual De Uso E Instalación página 5


The installation must be done by qualified technician according with the legal European

Before the installation check if the selected installation place fulfils the security distances which


Before the hands dryer electrical connection it must be installed a bipolar switch with 3 mm contact

The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
Do not plug the hands dryer laid over sinks, bath tubes,
shower or whatever place where could be in contact with
water, in an exceptional way as well.
INSTALLATION:
fig-1. In order to open the cover, remove the two screws placed in the bottom part of the hands dryer.
Separate the cover pulling down first and out in a second step.
fig-2. Mark up the four fixing holes on the wall using the hands drier rear base as a drill template. Make four
8 mm drills.Fix the rear base using the subjection screws.
fig-3. The Electronic Board allows sensor sensibility (Front view, down side potentiometer). Sensibility
increases turning the potentiometer clockwise. Please consider also the attach scheme to make these
changes.
fig-4. Using a switch placed at PCB bottom, it is possible to change total hand dryer power between 1200 W
(position 0) and 2050W (position 1).
fig-5. Assembly the cover on the hands dryer base again doing the opposite movements described at FIG1.
Tight the two screws removed before. When cover was definitively adjusted, plug the appliance to
electricity.
The hand dryer operation is produced by physical proximity. When you place the hands below the
hands dryer it will operate continuously, when you remove the hands from this position it will stop automatically.
HAND DRYER MAINTENANCE
The sole maintenance operations that you must make over the hand dryer are to extract the dust from
heating element and ventilator, and the external cover cleaning. In order to make the last one, take care and do
not use aggressive products which could damage the cover. In any case, to use a wet rag without any other
product is recommended.
To extract the dust from hand dryer internal components, follow the below instructions:
1. Unplug the hand dryer from electricity.
2. Remove the front cover as it is explained in fig-1.
3. Remove the dust from all components using a soft brush.
4. It is very important to clean perfectly the heating element, the blower, the air inlet and the air
outlet.
5. Be sure that sensor is perfectly clean.
INSTALLATION MANUAL:

Before any electrical manipulation, cut the electrical current.
appears at the CEI standards.(fig-0)
The hands dryer could not be installed on a normally inflammable surface.

Children being supervised not to play with the appliance
ATENTION!
ATENTION!
Standards.
opening gap.
or instruction
If the plug cord is damaged, it must be substituted by the
manufacturer, by an authorized technical assistance service
or by qualified people to avoid danger situations. Plug cord
USER'S MANUAL:
ATENTION!
reference is 60/0341