Bühler technologies APO 998BX460014 Guía Rápida página 5

APO
If the probe is transported to the installation site in pieces, it
will first need to be assembled.
4.2 Installation
The probe consists of the APO-G base body the sampling tube
you selected screws onto. If the probe is transported to the in-
stallation site in pieces, it will first need to be assembled. This
is limited to screwing in the sampling tube and, if necessary,
the corresponding extensions. The probe is then attached to
the mating flange using the corresponding seals and screws.
The sample gas line must be carefully and properly connected
using a suitable fitting (G 3/8").
WARNING
Hazardous electrical voltage
The device must be installed by trained staff only.
5 Operation and controls
NOTICE
The device must not be operated beyond its specifications.
5.1 Before Start-Up
Before starting the device, verify
• the hose connections are not damaged and correctly in-
stalled.
• no parts of the gas probe have been removed.
• the gas inlet and outlet of the gas probe are open.
• ambient parameters are met.
• type plate information and technical specifications were
observed!
• whether cable glands are sealed properly.
6 Maintenance
Always observe the applicable safety- and operating regula-
tions when performing any type of maintenance. Please refer
to the original operator's manual on the included CD or online
at www.buehler-technologies.com for maintenance informa-
tion.
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
8 Disposal
The applicable national laws must be observed when dispos-
ing of the products. Disposal must not result in a danger to
health and environment.
The crossed out wheelie bin symbol on Bühler Technolo-
gies GmbH electrical and electronic products indicates special
disposal notices within the European Union (EU).
BX460014 ◦ 01/2020E
The crossed out wheelie bin symbol indicates
the electric and electronic products bearing
the symbol must be disposed of separate
from household waste. They must be properly
disposed of as waste electrical and electronic
equipment.
Bühler Technologies GmbH will gladly dis-
pose of your device bearing this mark. Please
send your device to the address below for this
purpose.
We are obligated by law to protect our employees from haz-
ards posed by contaminated devices. Therefore please under-
stand that we can only dispose of your waste equipment if the
device is free from any aggressive, corrosive or other operat-
ing fluids dangerous to health or environment. Please com-
plete the "RMA Form and Decontamination Statement", avail-
able on our website, for every waste electrical and electronic
equipment. The form must be applied to the packaging so it is
visible from the outside.
Please return waste electrical and electronic equipment to the
following address:
Bühler Technologies GmbH
WEEE
Harkortstr. 29
40880 Ratingen
Germany
Please also observe data protection regulations and remem-
ber you are personally responsible for the returned waste
equipment not bearing any personal data. Therefore please
be sure to delete your personal data before returning your
waste equipment.
Bühler Technologies GmbH 5