CruxCare C2 Manual Del Usuario página 14

3
Step
Connect up to 3 devices
1. While the C2 Pager is in Connecting mode (Step 2), trigger the first device.
Depending on the type of accessory, you will receive a confirmation of successful
connection on the C2 Pager as outlined in the table below. The sound that
confirms a successful connection can be stopped by pressing "STOP" for about 1
second. When the device is connected, you can exit the connection mode for that
device, as outlined in the third column.
Accessory
CruxCare call button Pro
(CCBS-01)**
CruxCare bathroom call
button Pro (CCBR-01)
CruxCare call buttons
red & blue
(CCCB01R and CCCB02B)
CruxCare bed mat Pro
(CCBP-01)*
Tiiwee Window/Door
Sensor (TWWS03
IMPORTANT: not all products are available in all countries.
*IMPORTANT: For pairing the CruxCare bed mat, switch on the bedmat transmit-
ter while the C2 Pager is in connection mode.
**IMPORTANT: Before pairing this device, please open the battery compartment
and insert the included batteries.
Connection Indication
The respective "DEVICE"
LED will flash, and you will
hear notification sounds
The respective "DEVICE"
LED will flash, and you will
hear notifications sounds
The respective "DEVICE"
LED will flash, and you will
hear notification sounds
The respective "DEVICE"
LED will flash once
The respective "DEVICE"
LED will flash, and you will
hear notification sounds
12
What you do:
After 10 seconds, stop the
notification sound by pressing
the "STOP" button for 1 sec.
After 10 seconds, stop the alert
by pressing the "STOP" button
for 1 sec.
Stop the alert by pressing the
"STOP" button for 1 sec.
no action required. Once the
"DEVICE" LED has lit, the device
is successfully connected.
Stop the alert by press the
"STOP" button for 1 second