Replacing Carbon Brushes - Makita 1902 Manual De Instrucciones

MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the chip cover.
010669
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
010706
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
1. Limit mark
1
1. Chip cover
1
2. Screwdriver
2
1. Brush holder
1
cap
2
2. Screwdriver
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
High-speed steel Planer blade
•
Tungsten-carbide Planer blade (For longer blade
•
life)
Mini planer blade
•
Sharpening holder assembly
•
Blade gauge
•
Set plate set
•
Edge fence (Guide rule)
•
Extension guide set
•
Dressing stone
•
Nozzle assembly
•
Dust bag assembly
•
Socket wrench
•
8
or attachments
Only use accessory or
are