Sharpening The Conventional Planer Blades (Optional Accessory); Replacing Carbon Brushes - Makita KP0800 Manual De Instrucciones

Sharpening the conventional planer blades
(optional accessory)
002588
Always keep your blades sharp for the best performance
possible. Use the
accessory) to remove nicks and produce a fine edge.
1
2
3
002589
First, loosen the two wing nuts on the holder and insert
the blades (A) and (B), so that they contact the sides (C)
and (D). Then tighten the wing nuts.
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the blades
both contact the dressing stone for simultaneous
sharpening at the same angle.
002590

Replacing carbon brushes

001145
1. Sharpening
holder
1
sharpening holder
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
5
4
1. Limit mark
1
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
(optional
010335
Use a screwdriver to remove the chip cover.
1
010186
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
High-speed steel Planer blade
•
Tungsten-carbide Planer blade (For longer blade
•
life)
Mini planer blade
•
Sharpening holder assembly
•
Blade gauge
•
Set plates set
•
9
1
2
2
accessories or
persons. Only use
1. Chip cover
2. Screwdriver
1. Brush holder
cap
2. Screwdriver
attachments are
accessory or