ControlloCasa USBy v3 Manual Del Usuario página 17

V 3.0
:
ERSIONE
2. USER MANUAL (ENGLISH)
CONDITIONS OF USE: the USBy device bases its operation on the Internet connection.
Therefore we recommend that you power the USBy device to the USB port of your Router or
to an electrical outlet near the Router (1-3m). This will ensure the best conditions for using
the device. If these conditions are not respected, the service provided by the device may not
be guaranteed.
Please, follow the instructions below to correctly install USBy.
2.1 USBy Installation
In order to use USBY we need to perform 2 operations:
• Connect USBy to the Router/ Modem to be able to access the Internet
• Register USBy on the ControlloCasa site to receive alerts
2.1.1 Connect USBy to the Router / Modem
1. Turn on USBy by preferably connecting it to the USB port of your Router/Modem or to
the electrical outlet using an adapter (e.g. adapter used to charge mobile phones) near
the Router / Modem (ca. 1-3m)
2. Make sure that the light on the inscription "USBy" lights up when you switch it on
3. From your PC/Mac open the list of WiFi networks and select the network created by
USBy (e.g. USBy-V3_XXXXXX)
It is normal for the WiFi networks icon to show that there is no Internet access
(sometimes highlighted with the "!" symbol). In fact, you are currently connected to
the local network created by USBy which cannot access the Internet.
If the network created by USBy is not displayed in the list of WiFi networks,
deactivate and reactivate WiFi on your PC/Mac. Then, wait a few seconds and repeat
the search for the network created by USBy.
4. Open your web browser and enter the following address : 192.168.4.1
At this point the following graphic interface will be displayed.
www.ControlloCasa.it info@controllocasa.it
Page : 17/67
+39 06 94804820