Daspi DS058 TX MULTI Manual página 4

1. HOW TO COPY A STANDARD FIXED AND ROLLING CODE REMOTE:
1. Place the original remote you need to copy close to your TX Multi,
aproximately 2-4 centimeters distance between each other.
2. Hold TX Multi button 1 (upper-left) and, while holding it, press 3 times the
button 2 (upper-right).
3. Release both buttons and make sure the LED of TX Multi flashes slowly.
4. Now press the button of the original remote you want to copy and wait until
the LED changes its flashing frequency (now it flashes faster). This confirm
us the correct copy of the remote. This process can take few seconds.
5. While the LED is flashing, hold the button of TX Multi you want to copy the
remote until the LED turns off.
6. The remote has been copied successfully.
NOTES:
- If LED it stays fixed and turns off, the original remote will not have been
correctly copied. Please, repeat the process from step 1.
- To programme another button of TX Multi, repeat process from step 1.
2. HOW TO COPY A COMPLEX ROLLING CODE REMOTE: BFT or Erreka
1. Place the original remote you need to copy close to your TX Multi,
aproximately 2-4 centimeters distance between each other.
2. Hold TX Multi button 1 (upper-left) and, while holding it, press 3 times the
button 2 (upper-right).
3. Release both buttons and make sure the LED of TX Multi flashes slowly.
4. Now, press the button of the original remote we want to copy and wait until
TX Multi's LED remains on. Afterwards, it will start flashing twice every 2
seconds aproximately.
DS058 TX MULTI
Copy multi-frequency remote control
4