MSW Motor Technics MSW-TW-ET20000 Manual De Instrucciones página 30

• Refill the fuel tank, paying attention to when the gauge
approaches the "F" position (full tank), then stop refuelling and
tighten the fuel cap.
• Wipe off any spilled or dripped fuel immediately with a dry cloth.
If the unit has cooled down completely, the greasy stains from the
fuel can be removed with a cloth lightly dipped in benzine or
alcohol.
3.3.2 Working with the device
After a general inspection of the device for damage and refilling the
fuel in the tank if necessary, proceed to the following:
•
•
•
•
•
•
Connect the plug to a suitable power outlet.
Set the power switch to the on ("I") position.
Set the desired temperature with the temperature control
knob.
IMPORTANT: If the set temperature is higher than the
ambient temperature in which the device is located, it will
turn on. When the ambient temperature reaches a value
higher than the temperature set on the device, it will
automatically turn off. If the ambient temperature drops
below the set value, the device will restart.
When the temperature set on the device is lower than the
ambient temperature during the first start-up, the device
will not start up until the ambient temperature is lower than
the set temperature.
Before turning off the unit, set the knob to the lowest
temperature, then set the power switch to the off ("O")
position. When the fan stops, disconnect the plug from the
power supply.
NOTE: if the device works in breaks/bursts flames or does
not heat (despite the fuel being in the tank), adjust the
pressure on the turned-on device by turning the screw
located next to the manometer (see the following 3 pictures)
using, for example, a suitable size screwdriver with a flat tip:
When the unit bursts flames - counterclockwise until its
operation is stabilized - then leave the screw in this position.
When the device does not heat up, turn the screw clockwise
until it starts to heat normally - then leave the screw in this
position