Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Dear customer,
Thank you for purchasing an ALFRA product. Please read these operation instructions closely before using
your device for the first time and keep them for later reference.
SAFETY INSTRUCTIONS
!
• Do not overload the assembly table! Prior to any use, there should be a check that the
prescribed maximum load of 200 kg will not be exceeded.
• During use, no one should remain sitting or standing on the assembly table.
• Make sure that the loaded assembly table has been secured against unintended rolling.
• Ensure that the load is evenly distributed over the assembly table's entire work surface.
• The assembly table was designed for even, firm surfaces and is therefore not suitable for
sloping, uneven surfaces.
• Loading and unloading should only be carried out in the horizontal position.
• The assembly table was designed for enclosed areas and is therefore not suitable for work
in the open air.
SPECIFIED CONDITIONS OF USE
The AMT 150 is used to set up and wire mounting plates up to max. 1100 x 1900 mm (W x H).
!
The observance of all instructions and the compliance with the required operating
conditions are part of the specified conditions of use.
7
Publicidad
