Publicidad
Idiomas disponibles
Idiomas disponibles
3. In order to set the upper pull-out part to the width of the mounting plate, the work surface must be in
the horizontal position. Loosen the clamping lever (3) and adjust the adapter plates to the desired width.
The adapter plates must be positioned in such a way that the retracted stop bolts (4) fit tightly on the
inner side of the mounting plate's U-section. After adjusting the width, tighten the clamping lever (3) again.
In order to fix the mounting plate, pull the stop bolts (4) back and turn the lever to the left. The stop bolt
is now retracted. Now attach the mounting plate and turn the stop bolt back again. The stop bolts will be
extended and the mounting plate is fixed.
4. Now the work surface can be wound into the desired position using the supplied crank (5).
5. In order to take the finished mounting plate off again, the work surface must be brought into the
horizontal position. Now loosen the knurled thumb screws in the lower pull-out part and pull back the
locking bolts on the upper part and turn them until they stay in. Now the mounting plate can be removed.
REPAIR AND MAINTENANCE
Repair and maintenance should be carried out regularly, as it extends the operating life of the assembly table.
9
Publicidad
