Publicidad
Idiomas disponibles
Idiomas disponibles
4
TECHNICAL SPECIFICATIONS
Sensor protection rating
Control unit protection rating
Control unit input voltage
Maximum relay load/voltage
5
FAQS
Question
The control unit is not showing the levels.
The sensor is properly connected, but is not
showing the levels accurately.
In other cases or if the answers have not resolved the problem detected, contact a service
engineer (see the list of approved engineers on the product's warranty).
6
PRODUCT LABELLING
IP68
Not
protection
operational
rating
T < 4 °C
7
WARRANTY
See attached document "Warranty certificate for fountain units".
Installation, operation and maintenance manual; Level Control System
Answer
Check that the unit is connected to the
power supply and that it is properly
connected.
Adjust each of the relays' potentiometers
( ④
④ ) until accurate readings are obtained.
④
④
Check that there is nothing obstructing the
unit that prevents it from detecting the water
level.
Safe management of
waste electrical and
electronic equipment
Directive 2002/96/EC
(WEEE)
Fountain units
IP-68
IP-20
230 V AC
2.5A/230 V AC
4A/24 V CC
The unit's
documentation
must be read
before use
Danger of
electric
shocks
23
Publicidad
