Dongcheng DZC05-26B Instrucciones De Operación página 8

1
2
To install the drill bit (SDS-plus shank), fully pull back
the locking sleeve and insert the drill bit as far as it
will go while rotating.
1
By releasing the slide grip, the drill bit will be secured
automatically.
To remove the SDS-plus drill bit, fully pull back and
hold the slide grip and the drill bit can be removed.
● Auxiliary Handle
Always use the auxiliary handle ensure operating
safety. Loosen the auxiliary handle by turning it
counterclockwise, swing it to the desired position
and then tighten it by turning clockwise.
1
● Switch Action
CAUTION:
Before plugging in the tool, always check to see
that the trigger switch actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger
EN
8
1.Drill Chuck
2.Lock Screw
3.Connecting Rod
3
1.Drill Bit
2.locking sleeve
2
1.Auxiliary Handle
and then push in the lock lever. To stop the tool
from the locked position, pull the switch trigger
fully, and then release it. The rotating speed of
the tool becomes faster and faster until it reaches
the full speed during the process of pressing the
switch.
1
The switch of DZC05-26B/AZC05-26B/KZC05-26B
is with positive inversion knob, which can be used to
change the tool's direction of rotation. You can only
change it when the tool completely stops rotating,
otherwise the tool will be damaged.
1
2
3
4
Depth Gauge
●
1.Loosen the wing bolt, and insert the depth gauge
into the fitting hole of the clip board.
2.Move the depth gauge to the desired depth and
secure it by rotating the wing bolt clockwise.
1
MAINTENANCE AND
INSPECTION
● Clean the vents
The vents of the machine must be kept clean. Clean
regularly or when congestion occurs.
● Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure
1.Trigger Switch
2.Lock Button
2
1.Corotation Arrow
2.Switch lever
3.Switch Button
4.Lock Button
1.Depth Gauge
2.Wing Bolt
3.Clip Board
3
2