Publicidad
Idiomas disponibles
Idiomas disponibles
Caution:
Instructions on the
label
b)
Continuous steam ironing
1. Fill the iron with water, in compliance with the filling methods.
2. Plug the appliance into the electrical socket.
3. Adjust the thermostat to the fabric to be ironed.
4. When the red LED on the bottom of the iron switches off, this means that you can
start to iron. The red LED on the handle is still on.
5. Adjust the intensity of the continuous steam with the slider.
Recommendations for use:
Iron slowly to that the steam can penetrate the fibres of the fabric.
c)
BURST function
The Burst function allows a maximum steam jet for a short time. This function is useful for
ironing out folds on creased items, hanging items, curtains, etc.
1.
Check that the tank has enough water.
2.
The temperature control button must be set to minimum on ••Wool.
3.
Plug the lead into an earthed power socket.
4.
Once connected to the power supply, the two red LEDs light up.
5.
When the red LED on the bottom of the iron switches off, this means that you can
start to iron. The red LED on the handle is still on.
6.
Adjust the slider to maximum and press the BURST button.
This iron can also be used in the vertical position with a steam jet.
Never point the steam jet at people!
Please take note that the following icon:
Type of fabric
Thermostat selector
Nylon
Silk
Wool
Cotton
Linen
means that the item cannot be ironed.
MIN
MAX
20
Publicidad
