Publicidad
Idiomas disponibles
Idiomas disponibles
7.5
EXTENSION OF THE POLE SAW
1. Fit the extension pole between the polesaw handle
and the polesaw head to achieve the maximum
length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tighten them.
WARNING
Periodically check the tightness of the connection
of the collars.
7.6
ATTACH MACHINE TO SHOULDER
STRAP
1
2
1. Attach the carabiner to the carrying ring on the drive
tube.
2. Put on the shoulder strap.
English
2
1
1
2
3. Adjust the length of the strap so that the carabiner is
about a hand's width below your right hip.
7.7
CUTTING PREPARATION
Before you start to cut, make sure that
•
Wear heavy gloves for maximum grip and
protection.
•
Maintain a proper grip on the machine during
operation.
•
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
•
Keep your body to the left of the chain line.
•
Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
•
Never stand directly under the limb you are cutting.
•
Periodically examine the tightness of the collars
during operation.
7.8
INSTALL THE BATTERY PACK
WARNING
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.9
REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9
EN
Publicidad
