Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT REMARKS
•
The installation must be done by a technician following the
safety norms in force. For the electric installation make
reference to the norm NFC15-100.
•
Only apply to authorized personnel to replace the feeding
cable of the motor.
•
Do not pierce nor insert screws in the whole length of the
motor.
•
Avoid any contact of the motor with liquids.
• Avoid to crush or knock over the motor.
• Possible tampering or wrong connections are not covered by
guarantee.
WARNING: the power supply cable should not be exposed to
sunlight or rain directly.
Note:
a) Please read the instruction carefully before installation.
b) Assure that all accessories have been fixed so that the motor
works without any mechanical problem. The loading weight
should be matched with the output power of the motor.
c) Electrical connection must be done by professional
technicians to operate in conformity with the rules.
WARNING: Important safety instructions. It is important for the
safety of persons to follow these instructions. Save these
instructions.
WARNING: Important safety instructions.
•
Follow all instructions, since incorrect installation can lead to
severe injury.
•
Do not allow children to play with fixed controls.
•
Keeps remote controls away from children.
•
Frequently examine the installation for imbalance and sings
of wear or damage to cables and springs.
•
Do not use if repair or adjustment is necessary.
•
The actuating member of a biased-off switch is to be located
within direct sight of the driven part but away from moving
parts. It is to be installed at a minimum height of 1.5 m.
•
Fixed controls have to be installed visibly.
•
The appliance can not be used in outside.
•
The installer must provide for a device (es. magnetotermical
switch) ensuring the omnipolar sectioning of the equipment
from the power supply. The standards require a separation of
the contacts of at least 3 mm in each pole (EN 60335-1).
•
Do not connect more than one motor for each command
button
EC DECLARATION OF INCORPORATION FOR
PARTLY COMPLETED MACHINERY
(Directive 2006/42/EC, Annex II-B)
The manufacturer
CIBOFER INTERNATIONAL s.r.l.
Via Asiago, 16 - 20061 CARUGATE (MI) Italia
Under its sole responsibility hereby declares that:
the partly completed machinery model(s):
CBC.090.60.OR
Description: electromechanical actuator for awnings and
rolling shutters
-
is intended to be installed on awnings and rolling shutters
to create a machine according to the provisions of the Directive
2006/42/EC. The machinery must not be put into service until
the final machinery into which it has to be incorporated has
been declared in conformity with the provisions of the Directive
2006/42/EC (annex II-A).
-
is compliant with the applicable essential safety requirements
of the following Directives:
Machinery Directive 2006/42/EC (annex I, chapter 1)
Low Voltage Directive 2006/95/EC.
Electromagnetic Compatibility Directive 2004/108/EC.
Radio Directive 99/05/EC
The relevant technical documentation is available at the national
authorities' request after justifiable request to:
CIBOFER INTERNATIONAL s.r.l.
Via Asiago, 16 - 20061 CARUGATE (MI) Italia
The person empowered to draw up the declaration and to provide
the technical documentation:
Stefano Ciriello
Legal representative of
CIBOFER INTERNATIONAL s.r.l.
Carugate, 28/01/2010
13
, headquarters in
Publicidad
