FAAC XKPR125D Manual Del Usuario página 17

4. CONNECTING TO THE DOOR CONTROLLER VIA SPINET
- Connect the Spinet Bus to terminal J23 as indicated in 3.
!
Every device connected to the SPINet line must have a unique address. Use the address Pins (4).
5. TROUBLESHOOTING
Indication
The device does not turn on.
The following message appears
when the XKPRD is switched on:
WARNING ! Multiple
Slave A on SPInet !
The display and the keyboard do
not light up when it is switched on.
A user code or tag is not validated,
an error message appears on the
display.
6. INFO DISPLAY
7
8
XKPRD
Possible causes
No power or device not working. Check that the power supply is
There are two readers with the
same address.
The illumination may be dis-
abled.
Software configuration error.
Off-line mode
When the symbol in the figure (7) is dis-
played, it indicates that the Door Controller, to
which the XKPRD Reader is connected, is not
communicating with the Network Controller.
On-line mode
When the symbol in the figure (8) is dis-
played, it indicates that the Door Controller,
to which the XKPRD Reader is connected, is
communicating with the Network Controller.
17
Translation of the original instructions
Necessary action
connected and live. If there are no
errors, replace the device.
Change the address for one of the
two devices.
Check the keypad and display con-
figuration for the Device in the
Keydom software.
Check the Access Media configura-
tion in Keydom.
EN
532229 - Rev.C