Metra 99-8731 Instrucciones De Instalación página 3

1. Secure the radio brackets to the radio
trim panel using (4) #8 x 3/8" Phillips
pan-head screws provided. (Figure A)
2. Slide the pocket into the bracket/panel
assembly, then secure using (4) #8 x
3/8" Phillips flat-head screws provided.
(Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/panel
assembly, then secure using screws
supplied with the radio. (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Slide the radio assembly into the dash,
then secure using the factory screws.
7. Attach the factory radio trim panel to
complete the installation.
KIT ASSEMBLY
(Figure A) (Figure B) (Figure C)
REV. 4/20/2022 INST99-8731
3