Silvercrest SAST 18 A1 Guía Breve página 13

Information about the batteries
■ The appliance runs on rechargeable lithium-ion batteries . Before using the
appliance for the first time, the batteries must be charged . The charge
indicator lamp
fully charged, the charge indicator lamp
■ If the charge indicator lamp
is almost completely discharged and the appliance switches off after approx .
1 minute . This protects the appliance from deep discharge .
Installation of the wall bracket
DANGER! ELECTRIC SHOCK!
► Ensure that there are no power cables or water pipes in the wall at the
location where you intend to drill the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be a mains power socket nearby . In addition, there should be no power
or water lines in the wall .
2) Drill two holes below each other at a distance of approx . 110 mm from each
other . The drill holes must be suitable for 6 mm wall plugs .
3) Push in the wall plugs and screw in the screws so that the heads protrude a
few millimetres .
4) Hang the wall bracket
that the screws slide into the slots . The wall bracket
against the wall . You can adjust the distance to the wall and compensate for
any unevenness in the wall by screwing in or unscrewing the screws .
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-out .
6) Push the two accessories holders
and right of the wall bracket
accessories holders
7) Place the barrel plug
from below . Secure the barrel plug
8) Plug the mains adapter
■ 10 │ GB │ IE
flashes red during charging . As soon as the batteries are
w
flashes alternately green and red, the battery
w
with the drill holes over the two screws and ensure
7
into the respective catches on the left
8
. You can place the nozzles in the
7
.
8
of the power adapter
9
9
into a power socket .
0
lights up green .
w
:
7
should lie flush
7
into the wall bracket
0
by turning it .
.
7
7
SAST 18 A1