Publicidad
Idiomas disponibles
Idiomas disponibles
screws (supplied) for the surface.
mum installation dimensions for the unit (cf. „spacings").
tion a heating unit indoors. This is possible with this HEATSCOPE
directive.
HEATSCOPE
heaters are basically made for outdoor use – and in most cases they are used outdoors
®
Many times a separate temperature system / thermostat acc. to ecodesign directive is already installed
sible to accomplish the EU standards of the ecodesign directive.
OPERATION, INSTALLATION INSTRUcTIONS AND mIN. DISTANcES
The HEATSCOPE
®
features two omnipolar „ON/OFF" switches. You can control the radiant heater manu-
ally using these selector switches on the unit itself.
The unit must be connected to a residual current circuit breaker and a fuse! Install the unit in any indoor
or outdoor areas. The heater is IP65 protected from water jets and dust.
CAUTION: The mounting of the heater on the wall and on the cieling as well as in glass houses and con-
the technical approval of the manufacturer. In the case of a deviant installation setting without approval
of the manufacturer danger for people and environment may occur. Warranty and guarantee expires for
installation on cumbustible surfaces.
All cables must be positioned so that they cannot come into contact with the surface of the radiant hea-
ter at any time. The radiant heater must not be installed directly below a power socket. The sides of the
HEATSCOPE
®
A M B I E N T H E A T I N G S O L U T I O N S
type. In combination with the optional
®
-
-
EN
-
Publicidad
