Heatscope PURE+NEXT Manual De Instrucciones E Instalación Original página 8

11. The power cable or buried cable with omnipolar switch may only be replaced by a profes-
sional specialist electrical company enlisted or approved by the manufacturer. Heating
organisation enlisted by the manufacturer. If you yourself or someone enlisted by you car-
installation or operation shall invalidate the guarantee immediately.
12. If the heater was installed inappropriately or was connected unhomogeneously with the
ating of the device. If overheating of a carbon heating element occur due to interlinkage
EN
high temperature resistant front screen of the heaters provide best protection of the
installed carbon heating elements. If a system malfunction inside the device causes
necting regulations with tested and approved luster terminals are part of the delivered
equipment.
13. The radiant heater must not be installed directly below a power source/socket. The sides
this power source.
switch or controller of the heater. If the HEATSCOPE
such a way that they cannot be touched by persons who are in direct contact with water.
one heating element visibly „glows" as soon as the unit is switched on.
15. The heater must not be installed nor operated in environments containing chlorine (like
inside pool areas) or salt (like near the coast).
angle or removing it from the wall/ceiling. Wait until the heating elements are not glowing
Even after a mechanical break of the quarz
is installed in such an environment
®
-
-
-
-